Sonar Harbor field notes
Follow the connection from the display.
Begin with the named display and its supplied sensor. In this range, Harbor Four uses the H4 four-pin connection, while Reach Seven uses the R7 eight-pin connection. The separate H4 replacement sensor is listed only for Harbor Four. Similar appearance is insufficient evidence that a third-party connector carries the same signals. Keep the cable route, available nominal twelve-volt supply and intended mounting position in the selection rather than choosing solely by screen size.
A transom bracket needs a position consistent with the actual sensor instructions. On a kayak, measure the round accessory rail before selecting the support arm and check that the craft can safely carry the assembly. The arm is a mechanical support and cannot adapt an electrical connector. Sonar displays show acoustic returns, which vary with water, speed, aeration and installation. They do not establish that water is safe to navigate. Compare the parts before recording the request, then follow the equipment documentation and seek appropriate installation guidance for the real craft.